EC - Aerial sliding rail duct extraction system with round profile
Wall-fixed or ceiling-fixed, single or centralized exhaust gas extraction system, with manual sliding along the extraction length
The sliding rail system EC is used in exhaust gas extraction plants, as single stations or centralized systems. These systems allow the extraction of exhaust gases off the vehicles in the following applications:
- car inspection centers and car workshops with moving vehicles (along the rail) with specific nozzles according to the exhaust tail pipes;
- centralized plants for lifting decks or multiple working areas, where it is not convenient the use of fixed extraction systems.
The aerial sliding rail duct EC is characterized by a round profile made of extruded aluminium. The special profile is studied to guarantee a perfect sealing even in case of low negative pressure and high temperatures. The ducts are pre-assembled during the production, in particular the insertion of the rubber in the aluminum profile, as it is not easy to carry out this operation during the installation in the workshop. The EC is supplied in modular kits of different sizes for the realization of personalized lines, depending on the request of the single workshop. All kits are provided with ESK support brackets, connections, top end flanges, outlet Ø 200 mm.
- EC - 12 different kits with size comprised between 4 and 40 m
Note: It is necessary to add the wall/ceiling brackets every 2 m.
The aerial sliding rail duct EC is made of extruded magnesium-aluminium alloy bars supplied in kits of different sizes. It shows an exlcusive sailing system with a wing rubber lip designed by Aerservice Equipments to resist gases and high temperatures. The sealing profile is studied for an easy movement of the internal sliding device. Trolleys adapt to different uses and are equipped with bearings for an easy sliding on the profile of the duct. Movement of trolleys can be done manually by the operator, either using the flexible hose connected to the trolleys or using ropes with handle in case of hose reels.
The system can mount an extractor fan directly on the duct for connection to expulsion ductwork. In case of complex plants or multiple users, the fan is installed close to technical locations, on the floor or fixed to a wall. In case of big plants, the fan can also be installed outside the building. Our technical department can give support for the design of the plant and of the rigid pipes for gas extraction. The EC can also mount a rigid extraction hose instead of a trolley with flexible hose or a hose reel.
- - Easy to install thanks to the pre-assembly of the rubber lip into the alluminiun profile;
- - High resistance to the torsional stress happening during the working process.
|Aerial sliding rail profile||round|
|Maximum air flow||2000 m3/h|